Imágenes adicionales
WB-PowerLink2-BLK-A
WB-PowerLink2-BLK-A

Acondicionador de voltaje Wattbox

WattBox PowerLink2 with Duplex Wall Plates and 3 Ft Power Cord - Kit negro


Código: 01-WB-PowerLink2-BLK

WattBox™ PowerLink2 Kit with Two Recessed 110V Electrical Wall Plates and 3ft Power Cord (Black)

Important Note: This product is the replacement for the PowerLink2-BLK

PowerLink2 has the installer interests in mind.
We offer the PowerLink2 because it solves practical installation issues such as hiding power cables while saving installation costs. This solution provides a clean professional installation for hiding power cables. It allows the equipment (i.e. televisions) to be protected by the same surge and power device that is protecting the AV equipment. No need for expensive in-wall surge protection equipment. And the dual outlet gives flexibility to power additional equipment such as baluns, DVD players, etc..

 

Hiding Power Cords For An In-Wall TV Installation is a Snap!
We've timed the installation and in about 20 minutes you can provide power from your AV equipment to the television and not have an unsightly power cable running down a wall to the nearest power outlet. Simply install the power inlet box near your AV equipment and the dual outlet box behind your television and run ROMEX® to connect the two boxes and you're done.

Episode Power Products




ETL LISTED
This listing conforms to UL STD 498, UL STD 514D, certified to CSA STD C22.2 No. 42-99, C22.2 No.42.1, C22.2 No.85.

Shares a Common Ground with External Surge Protection
Just plug the included power cord into your surge protector and connect to the PowerLink2 inlet. By running all audio and video equipment through a common surge protector, you'll avoid complications caused by ground loops.

Recessed Inlet Receptacle and Duplex Outlet Receptacle
For clean, low-profile installations such as wall mounting televisions.

Includes:
(2) Work Boxes
(1) Recessed Male Inlet faceplate with screws
(1) Duplex Outlet faceplate with screws
(1) 36" 3-Prong POWER CORD
(6) Wire Nuts

Tools & Materials Needed:
- ROMEX® or equivalent non metallic type building electrical wire.
- Stud Finder
- Tape Measure
- Pencil
- Level
- Drywall Saw/Sharp Utility Knife
- Phillips and flat head screwdriver
- Wire Stripper
- Electrical Outlet Tester
ROMEX® is a registered trademark of the Southwire Company.

Two Outlets Instead of One!
Many installers use Cat5/6 in the walls to run component, composite, and HDMI signals from the equipment to the television. We purposely included dual outlets to take advantage of installers needs for today's and tomorrow's future applications.

(Also needed: 3-Conductor ROMEX® Electrical Wire- NOT SUPPLIED)

Note: THIS PRODUCT IS NOT TO BE HARD-WIRED DIRECTLY TO AN ELECTRICAL CIRCUIT. IT IS DESIGNED AS AN ELECTRICAL PLUG-IN DEVICE TO USED WITH AN EXISTING A/C GROUNDED OUTLET ONLY.

THIS PRODUCT IS RATED FOR USE WITH AN EXISTING OUTLET 15-AMP 125V GROUNDED CIRCUIT ONLY.
Check with your Local Building Jurisdiction, as to permit or code requirements for installing electrical wire and outlets within a wall.

This product does not have built-in electronic circuitry for surge protection or A/C filtering. It is recommended that you use a quality surge-protector/power conditioner.

If you are not skilled with running wires through walls it is strongly recommended that you consult with a qualified installation professional. SnapAV IS NOT LIABLE FOR ANY DAMAGES DUE TO IMPROPER INSTALLATION.